Skip to content
Makeup to Makeout
Menu
Woman touching her face while looking in a bathroom mirror

How Do You Apply Concealer? A Step-by-Step Guide

How to apply concealer properly: prep the skin, match the shade, blend under the eyes and cover blemishes without caking or creasing.

How to apply concealer: the short answer

Concealer is a targeted product, not a second foundation. You need a very small amount — roughly a grain of rice per area — dotted onto the skin and then tapped and pressed into place rather than swept around.

The order that works for most people is: eye makeup, then foundation, then concealer, then a light powder only where the product is likely to move. Build in thin layers and stop as soon as the area looks even.

  • Under the eyes: dot at the inner corner and the darkest part of the shadow, then press in with a fingertip or a damp sponge.
  • On blemishes: a pinhead of product directly on the spot, blended only at the edge.
  • Around the nose and mouth: thin layers pressed on, not rubbed.
  • Never drag or sweep the product across the skin — that is what causes patchiness.

What you need before you start

You do not need much kit, but the state of your skin and the light you are working in matter as much as the product.

  • Clean hands, and a clean fingertip, small synthetic brush or damp makeup sponge.
  • Your usual moisturiser, given a few minutes to absorb.
  • A mirror you can get close to, ideally with daylight or a daylight bulb nearby.
  • Tissues and a dry cotton bud, for tidying edges and catching fallout.
Amount for under the eyes
One dot per eye, no bigger than a grain of rice
Amount per blemish
A pinhead of product, built up if needed
Best tool for the under-eye
Clean ring finger or a damp makeup sponge
Best tool for spots
A small, flat synthetic brush for precision

Match the shade and pick the right formula

Two rules cover most of it. Under the eyes, go no more than one shade lighter than your skin and match the undertone — too light, and the area turns grey or ashy. On blemishes, match your skin exactly, because a lighter dot simply highlights the spot you were trying to hide.

If a dark circle or a patch of redness still shows through after concealer, the problem is colour rather than coverage. A thin colour corrector underneath neutralises it: peach or salmon for blue-brown circles, green for redness. Correctors add colour, not coverage, so keep them to the discoloured area only.

Concealer formats and what each one is good at

Format

Best for

Liquid
Under-eyes and everyday spots; the easiest to build in thin layers
Cream (in a pot)
Dry or mature skin, and areas prone to creasing
Stick or pencil
Small, precise blemishes and patches of redness
Colour corrector
Dark circles and redness that show through concealer

Coverage

Liquid
Light to medium
Cream (in a pot)
Medium to full
Stick or pencil
Full
Colour corrector
Sheer colour, almost no coverage

How to apply it

Liquid
Dot on and tap in with a fingertip or damp sponge
Cream (in a pot)
Warm between fingertips, then press on; use less than you think
Stick or pencil
Draw the tiniest amount onto the spot and blend only the edge
Colour corrector
Under concealer, on the discoloured area only

Step by step: how to apply concealer

  1. 1. Start with clean, moisturised skin

    Cleanse and apply your usual moisturiser, then let it absorb for a few minutes. Concealer sits on top of skincare, so anything slippery or still wet on the surface will make it slide and separate.

  2. 2. Do your eye makeup first

    Mascara, liner and eyeshadow fallout is easy to brush off bare skin and awkward to repair on top of concealer. Finish the eyes, then remove any specks with a dry cotton bud.

  3. 3. Apply foundation, if you are wearing it

    Concealer is for the areas foundation did not quite cover. A sheer layer all over means you need far less concealer, and using less concealer is the single biggest reason it stops looking heavy.

  4. 4. Warm a small amount on the back of your hand

    Tap out one dot per area onto the back of your hand rather than straight from the wand. It warms the product, lets you control the amount and keeps the applicator away from your spots.

  5. 5. Dot the product onto the darkest part only

    Place it at the inner corner under the eye, on the centre of a blemish, or on the reddest part of the nose. Small dots let you build up; a drawn-on stripe or triangle is much harder to control.

  6. 6. Tap and press, never sweep

    Use your ring finger — the lightest touch — or a damp sponge, and press the product into the skin in short taps. Sweeping drags it across the surface and takes off the coverage you just put on.

  7. 7. Build in thin layers

    Give each layer a few seconds to settle before adding the next. Two thin layers cover more convincingly than one thick one and are far less likely to settle into lines.

  8. 8. Blend the edges, not the middle

    Soften only the outer edge so there is no visible line, and leave the centre of the blemish or the darkest part of the shadow alone. Then press a whisper of loose powder only where the product creases or shifts.

Under-eye concealer without creasing

The skin under the eye is thin and moves constantly, so it forgives very little. Keep the concealer where the shadow actually is — usually the inner corner and the hollow just below it — rather than covering the whole undereye and out towards the cheekbone.

Skip heavy eye cream immediately before concealer. If the cream has not absorbed, the concealer floats on top and gathers in every line within the hour. If your eyes are dry, use the cream at night and a lighter layer in the morning.

Blemishes, redness and spots

Spots need the opposite approach to under-eyes: full coverage, a precise tool and no powder on top. Load a small flat brush with a pinhead of concealer, place it directly on the spot, then soften just the outer edge with the clean side of the brush or a fingertip.

If the skin around the spot is flaky, no concealer will sit smoothly on it. A gentle exfoliation a day or two beforehand and a layer of moisturiser will do more than adding product. For redness across the nose and cheeks, thin layers pressed on with a sponge look far more natural than a single thick one.

Avoid concealing broken skin, scabs or anything that looks infected — the product collects in the broken surface and makes it more obvious, and it traps bacteria.

Foundation or concealer first?

For most people the working order is:

  • Eye makeup first, then tidy fallout.
  • Foundation in a sheer layer all over.
  • Concealer only on what is still visible.
  • Powder pressed on sparingly, then setting spray if you use one.

If you wear only one base product, concealer alone is fine — dot it where you need it and leave the rest of the face bare. If you only need to correct colour, a little corrector under a light concealer gives a more natural result than a heavier concealer alone.

What goes wrong, and how to fix it

What you see

Likely cause

Grey or ashy under the eyes
Concealer too light, or the wrong undertone for the shadow
Creasing within an hour
Too much product, or an eye cream that has not absorbed
Cakey patches on spots
Concealer over dry, flaky skin, or powder over a creamy product
Obvious pale rings
Concealer spread too far down the face, or edges left unblended
Gone by lunchtime
Applied over skincare that has not set, so there is nothing to grip it

Fix

Grey or ashy under the eyes
Go one shade lighter at most, match the undertone, and add a peach corrector underneath
Creasing within an hour
Blot the excess, press a whisper of powder on top, and use less next time
Cakey patches on spots
Exfoliate and moisturise first; press concealer on and skip powder on spots
Obvious pale rings
Keep it to the inner corner and shadow area, and soften only the outer edge
Gone by lunchtime
Let skincare absorb, use less product, and set lightly where it shifts

Hygiene and eye safety

Concealer goes near the eye and onto broken skin, so hygiene is not fussiness. Wash your hands, keep the applicator away from spots, and sharpen or wipe pencil tips before use.

Frequently asked questions

Can I apply concealer with my fingers?
Yes. Clean fingertips warm the product and press it in gently, which works particularly well under the eyes. For small blemishes, a tiny flat synthetic brush gives you far more precision.
Why does my concealer crease under my eyes?
Usually too much product, or a rich eye cream that has not absorbed. Use a thinner layer, blot any excess before setting, and press on a very small amount of powder only where the lines appear.
Can you use concealer instead of foundation?
Yes, on days when you only want to even out a few areas. Dot it on redness, any spots and under the eyes and stop there — used all over the face it tends to go patchy and flat, because it is designed to be thicker than a base.
Can you use concealer as an eyeshadow base?
It can work if the formula is thin and you set it with a little powder first. Heavy under-eye concealers make eyeshadow slide and settle into the crease.
Does concealer expire?
Yes. Look for the small open-jar symbol on the packaging, which usually gives 6 or 12 months after opening. Bin it sooner if it separates, smells different or irritates your eyes.
Should I put concealer on a spot that is scabbing over?
No. Concealer collects in the scab and looks patchy, and it can slow healing. Wait until the skin has closed, then press on a small amount with a brush instead of dragging it across.

Related articles