Skip to content
Makeup to Makeout
Menu
Makeup artist applying eye makeup with a brush to a client

How to Apply False Eyelashes (Strip and Individual)

A step-by-step guide to applying false eyelashes cleanly at home, from trimming and gluing the strip to fixing lifting corners and removing safely.

The short answer

A false lash strip sits on the eyelid, just above your natural lash line — never on the waterline and never touching the roots of your own lashes. Measure it against your eye, trim it to fit, run a thin line of glue along the band, wait until the glue turns tacky rather than wet, then press the strip down in the middle first and work outwards to each corner.

The whole job takes about five minutes once you've done it a few times. Nearly every failed application comes down to one of three things: the strip is too long, there's too much glue, or the lash went on before the glue was ready.

What you need before you start

  • A strip lash in a shape that suits your eye. A thick, stiff band is much harder to seat flat than a thin one, especially at the inner corner.
  • Lash glue, clear or dark. Check the tube for latex if you've reacted to plasters or gloves before.
  • Fine tweezers or a lash applicator. Far easier than fingers, particularly at the outer end where you can't see what you're doing.
  • Small, sharp scissors for trimming.
  • A mirror you can look down into. A compact propped on a table beats a wall mirror, because you need your eyelid flat and your gaze lowered.
  • Cotton buds, a little oil-based cleanser and an eyeliner for tidying up and blending.

Prep your eyes and natural lashes

Work on clean, dry skin. Cleanse the lids and lashes, then make sure there's no moisturiser, eye cream, serum or oily cleanser left on the eyelid. Oil is the enemy of lash glue and one of the most common reasons a strip lifts within the hour.

Curl your natural lashes before the strip goes on. You can't use a curler afterwards without crushing the false lashes and bending the band out of shape.

If you're wearing mascara, apply a thin coat now and let it dry completely. Mascara that's still tacky grabs the glue and you end up with clumps where the two sets of lashes meet.

Measure and trim the strip to fit

Hold the strip against your closed eye with the outer end lined up just past your own outer lashes. The inner end should stop where your lashes start to thin out at the inner corner — not jammed into the tear duct.

Trim from the outer end, a couple of millimetres at a time, and re-check the fit each time. Leave the inner end alone: that taper is what stops the strip looking blunt and blocky.

If the band is stiff and springs away from your eyelid instead of following its curve, wrap it gently around a finger or a makeup brush handle for a minute. Most strips need softening the first time they come out of the tray.

How to apply a strip lash, step by step

  1. 1. Clean, dry and curl

    Wipe the eyelid with a cotton bud and a little cleanser, let it dry fully, then curl your natural lashes. Do this before any glue comes out of the tube.

  2. 2. Run a thin line of glue along the band

    Hold the strip by one end with tweezers and draw a thin line of glue along the band, adding a touch more at the two ends, which are always the first to lift. Don't blob it — a thick bead takes far longer to go tacky and oozes onto the lid.

  3. 3. Wait until the glue is tacky, not wet

    Wave the strip gently for around 30 to 60 seconds, following the timings on your own glue, until it changes from milky and wet to clear and sticky. Test it on the back of your hand: it should grip slightly, not slide.

  4. 4. Set it down in the middle of the lash line

    Prop a mirror on the table and look down into it so your eyelid lies flat. Place the strip at the centre of your lash line, as close to your natural lashes as you can get without touching the roots, then lower each end into position.

  5. 5. Press from the middle outwards

    Use the back of the tweezers or a clean fingertip to press along the band, working towards each corner. Go back over the inner and outer ends twice — those are the two spots that lift.

  6. 6. Blend the band into your lashes

    Close any gap between the band and your lash line with a thin stroke of eyeliner, then brush a light coat of mascara through your natural lashes only, at the roots, to marry the two together. Never put mascara on the false lashes themselves.

Individual clusters and magnetic lashes

Individual and cluster lashes are glued to your own lashes rather than to the skin, so they move with them and look softer. The technique is different: you need less glue — dip only the base of the knot — you place them one at a time with tweezers, and you work from the outer corner inwards so you can see the gap you're filling. Apply them to bare lashes, not lashes coated in mascara, and leave the innermost lashes alone if you want a natural finish.

Magnetic lashes come in two main types: strips that clip onto magnetic eyeliner, and pairs that sandwich your natural lashes between two magnets. Both need the eyeliner to be completely dry and wide enough for the magnets to catch, and the sandwich type needs enough natural lash to grip — they tend to slide on very fine or very short lashes.

What goes wrong, and how to fix it

The usual problems with strip lashes, and the fix that actually works.

Problem

What it looks like

The ends lift within an hour
The middle stays stuck but the inner or outer corner springs up
The strip slides while you place it
The band skates across the lid and won't stay where you put it
It sits too high above the lash line
A strip of bare eyelid shows between the band and your lashes
The inner end pokes and itches
A blunt, scratchy corner near the tear duct
White, crusty glue is visible
A pale line along the band that shows through the lashes
The outer corner droops by the evening
The false lashes start pointing downwards after a few hours
It hurts coming off
Removing the strip tugs at your own lashes

What to do

The ends lift within an hour
Usually too little glue at the corners, or a strip that's slightly too long. Re-trim and add a dot of glue to each end before pressing again.
The strip slides while you place it
The glue was still wet. Take it off, wipe the band, and wait longer until it's properly tacky.
It sits too high above the lash line
You're placing it above the lash line. Look down into a mirror and set it down right on the roots of your natural lashes.
The inner end pokes and itches
The strip is too long. Trim a couple of millimetres from the inner end, or switch to half strips.
White, crusty glue is visible
Too much glue, or it wasn't given time to turn clear and tacky. Use a thinner line, and dark glue if you're not wearing liner.
The outer corner droops by the evening
The strip is too long or too heavy for the shape of your eye. A shorter band with more flexibility holds its shape better.
It hurts coming off
The glue is still set. Soften it with an oil-based remover first — never pull a dry strip off.

Taking them off without damaging your lashes

Never pull a strip off dry. Soak a cotton bud with an oil-based cleanser or a dedicated lash-glue remover and hold it against the band at the outer corner for a few seconds. Once the glue softens, the strip lifts away; peel from the outer end inwards and support the eyelid with your other hand. If it resists, soak it again rather than tugging.

Wipe the old glue off the band with a cotton bud dipped in remover, reshape the strip on its tray and it's ready to wear again. Store strips flat and keep the glue tube closed and upright — glue that has gone stringy or smells odd won't hold.

Give your eyes a lash-free day now and then, and clean your lids properly every night so residue doesn't build up along the lash line.

Safety rules worth keeping

  • Never put glue on the waterline, on the inner rim of the eyelid, or on the eye itself. The band belongs on the skin above the lashes.
  • Don't share lashes, tweezers or glue with anyone else.
  • Don't sleep in strip lashes. The band presses into the lid all night and the strip warps out of shape.
  • Keep the tube away from your eye while you're loading the band. Squeeze glue onto the strip, never towards the lashes.
  • Stop using a glue or a lash style that leaves your lids red, itchy or swollen, and speak to a pharmacist if it doesn't settle.

Frequently asked questions

Can I wear false eyelashes with contact lenses?
Yes. Put your lenses in before you start so you're not handling your eyes with gluey fingers, and take the strip off before you remove your lenses at night.
How long should I leave the glue before applying the lash?
Until it's tacky rather than dry — usually somewhere between 30 and 60 seconds, depending on the glue and the room temperature. If the band still feels wet and slippery, it needs longer.
Can I reuse a strip lash?
Often, yes. Remove it gently, peel the old glue off the band with a cotton bud and remover, and reshape it on its tray. Once the band loses its curve or the hairs start shedding, it's time to replace it.
Should mascara go on before or after the lashes?
Before, and let it dry fully. After the strip is in place you can add a light coat to your natural lashes only to blend them, but mascara on the false lashes clumps them and shortens their life.
Why won't my false eyelashes stay on all evening?
The usual culprits are oily lids, too little glue along the band, or a strip that's a fraction too long and is being pushed up at the corners as you blink. Clean the lid, trim again and add a little extra glue at each end.

Related articles